广东安规
产品中心|灯头量规

当前位置: 首页 > 仪器设备 > IEC60061-3卡口杂类灯头量规
IEC60061-3卡口杂类灯头量规

BA9灯头通规|B15灯头通规|BA15灯头通规|B22灯头通规|7006-11-8

BA9灯头通规|B15灯头通规|BA15灯头通规|B22灯头通规|7006-11-8
  • 型号 : 7006-11-8
  • 品牌 : 广东安规
  • 标准依据 : IEC60061-3|GB/T1483.5
BA9灯头通规|B15灯头通规|BA15灯头通规|B22灯头通规(GO GAUGE FOR B15 CAPS ON FINISHED LAMPS)7006-11-8

详细描述

BA9灯头通规|B15灯头通规|BA15灯头通规|B22灯头通规(GO GAUGE FOR BA9 B15, BA15 CAPS ON FINISHED LAMPS)7006-11-8

 

目的:

检验成品灯具上BA9、B15、BA15和B22灯头的尺寸Amax、Nmin、D1min和D1max,以及销钉的径向位置。

 

检验:

将灯头插入量规,直至其销钉通过狭槽Q。然后,将灯头转动一微小的角度,并将其按压,从而使其销钉与S面紧密接触。在此位置上形成接触的面不应低于X面,也不应凸出Z面。
注:如果规定要求检验GB/T1406.5-7004-11所示尺寸Dmax,可采用类似的量规检验未组装的B15灯头。

 

Purpose:

To check dimension A max. , N min. , Di min. , Di max. , and the diametrical position of the pins of caps BA9, BA15 and B22 on finished lamps.

 

Testing:

The cap shall enter the gauge until the pins have passed through the slots Q. The cap is then turned through a small angle and is pressed so that the pins are in close contact with surface S. In this position, the contact-making surface shall not be below surface X nor shall it project beyond surface Z.

Note: A similar gauge may be used for checking unmounted caps B15 provided that provision is made for checking dimension D max. as shown on sheet 7004-11.

点击次数:  更新时间:2019-10-11  【打印此页】  【关闭
在线交流 
销售工号303 销售工号303
销售工号373 销售工号373
销售工号973 销售工号973
技术fasten 技术fasten
0769-23600626
sales@eychi.com
13650052332
13650000331

验证码:广东安规
否则拒绝!